Interface level gauge Tel: 0519-85911228 85910161 ultrasound (pulp) belongs to a non-nuclear density meter detection methods pulp density line detection instruments, with no radiation pollution, patented technology to eliminate the influence of the media bubble and slurry flow rate changes, on-site installation, The interface is simple gauge calibration may be suitable for different types of pulp density testing, with automatic temperature compensation function and so on. Working principle: Ultrasonic (slurry) concentration meter is based on ultrasonic wave propagation time in the pulp suspension such uniform, the amplitude of the measured particles with the number and size of the amount of solids in the slurry changes and variations ultrasonic attenuation measurements. As long as the measured quantity to be measured ultrasonic attenuation through the slurry can know when the slurry concentration tested. Under certain conditions, when the pulp particle is small, viscous attenuation plays a major role; when large particles, the scattering attenuation dominates. Technical parameters: size of the sensor: Φ25mm × h30mm sensor material 316 stainless steel, epoxy lined piezoelectric ceramics and environmental performance protection class IP65 (transmitter) IP68 (pipe-stage sensor)> IP68 (submersible sensor) Temperature Controller: -20 ~ 60 ℃ sensor: -50 ~ 100 ℃ maximum pressure 20Bar measuring the performance of precision 2% (1σ) resolution 0.5% of full scale range of 0% to 70% through a built-in temperature sensor Temperature compensation Automatic compensation of full scale analog output 4- 20mA, maximum 750Ω relay output high and low concentration alarm 220Vac power supply node communication interface RS485 interface level gauge, oil-water interface controller is less than 200VA RF capacitance water interface transmitter oil-water interface level meter powerful and easy to operate capacitive water Interface Transmitter interface level meter offer, due to the use of a special chip to design and unique dynamic summation algorithm, the first time the RF capacitive interface self-identification; the first time a highly simplified RF capacitive interface converter ; in order to achieve a practical remote transmitter dual interface interface signal level meter, fully reflects the company's innovative spirit and ability of the times! It is the height of the interface into the corresponding 4 ~ 20mA (ten) transmission signals for remote processing or component systems, among various oils (such as crude oil, heavy oil, etc.) and water applied to the dielectric constant of less than 3.5 The interface level measurement and control. Especially for petroleum, petrochemical, food and other industries. Main Specifications ◆ Power supply: AC220V ± 10% or DC24V ◆ power consumption: <3W ◆ Latency: <2 ~ 3 seconds ◆ Working temperature: -20 ~ 45 ℃ ◆ Probe working (medium) temperature: Normal : -20 ~ 60 ℃ medium temperature: -40 ~ 100 ℃ ◆ media pressure: pressure type ≤3MPa (other models of atmospheric pressure) ◆ output: 4 ~ 20mA transmitter signal (ten) ◆ Load capacity: 600 ohms ◆ Detection range: 11000p ◆ Sensor Protection grade: IP65 ◆ Accuracy: ± 10% FS interface hundred as a technological level gauge _ _ provided by the oil-water interface level gauge hundred Changzhou Technology Limited. Changzhou one hundred Technology Limited (www.czbckj.com) Jiangsu Changzhou, chemical instrumentation leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In one hundred as a technological leader with the staff warmly welcome all inquiries negotiations to create one hundred to a better future technology.